If your front panel audio cable has 7 wires 2 for Mic, 1 for ground, 2 for Left Channel output and 2 for Right Channel output , then use the Pin Layout 2 above to connect the audio cable. Avoid touching the components unless it is absolutely necessary. If you are using a processor cartridge that runs on a 66 MHz system bus, you can use memory that operates on a 66 MHz memory bus. Interest will be charged to your account from the purchase date if the balance is not paid in full within 6 months. All the ribbon cables used on the extension brackets carry a red stripe on the pin-1 side of the cable. On the mainboard, locate the J3 ATX header for this bracket.

Uploader: Tojarr
Date Added: 25 December 2016
File Size: 17.84 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 73913
Price: Free* [*Free Regsitration Required]

Lan Card Power On Your system can enter a software power down. You cannot install a Socket and a Slot-1 processor cartridge together.

See the Auto-Installing Under Windows 98 section. This amount is subject to change until you make payment. Graphic Win Size This item determines the operation of the onboard graphics adapter.

ShieldSquare reCAPTCHA Page

The setup window will appear as below. Locate the jumper JP The password is required at boot time, or m748lmr the user enters the setup utility.


It can even stop your computer from booting properly. Resume making your offerif the page does not update immediately. Press Enter after you have retyped it correctly. We recommend that you set this value to No. Mouse over to Zoom – Click to enlarge. The Modem-Riser-Card contains additional electronic Top 9. While installing the mainboard into AT case with ATX power, please make sure the AC power cord is unplugged before the full system is installed completely.

If you have two devices on the cable, one must be N748lmrt and one must be Slave. Ustaw SiS nie ! If a jumper cap is removed from two pins, the pins are OPEN. Remove the blanking plate from the appropriate expansion slot on the system chassis.

If you have already made changes to the setup utility, press F10 to save those changes and exit the m478lmrt. Take the following precautions when unpacking the mainboard and installing it in a system. To configure a hard disk drive, choose Auto. Amptron is not responsible for damages that may result in the improper connection of any USB device.

This locks the processor in the socket. If you are using a processor cartridge that runs on a MHz system bus, you must use memory that operates on a MHz memory bus PC memory. Reserved Memory Address This item lets you set the address for any block of memory that has been reserved. Follow the steps below to install a 4-speaker setup.



The jumper caps change the way the mainboard operates by changing the electronic circuits on the mainboard. Plug the cable from the bracket into the LAN header. Press F6 to install the setup utility with a set of default values. On the Socket, identify the pin-1 corner.

Suspend Time Out Minute This sets the timeout m748l,rt suspend mode in minutes. In these pages, use the cursor arrow keys to highlight the items, and then use the PgUp and PgDn keys to cycle through the alternate values for each of the items.

Use this jumper to select if you have installed a Slot-1 processor as right. Pull the struts upwards so that they are in the upright position.

Onboard FDC Use this item to enable or disable the onboard floppy disk drive interface.